Installing A Microprocessor - IBM Netfinity 6000R Installation Manual

Installing a microprocessor

Microprocessor slot 1 (J34)
Your server comes standard with one microprocessor installed in microprocessor
connector J34 (slot 1) on the system board, and a terminator card in microprocessor
slot 4. The microprocessor in slot 1 is the startup (boot) microprocessor. If more than
one microprocessor is installed, the highest numbered microprocessor is the
microprocessor from which the server will start. The lower numbered
microprocessors are used as application microprocessors.
Note: The illustrations in this document might differ slightly from your hardware.
Microprocessor slot 2 (J35)
Microprocessor slot 3 (J36)
Microprocessor slot 4 (J37)
PCI slot 1
Battery
32-bit
Memory board (J40)
PCI slot 2
64-bit
66 MHz (J51)
PCI slot 3
64-bit
66 MHz (J52)
PCI slot 4
64-bit
66 MHz (J53)
PCI slot 5
64-bit
33 MHz (J54)
PCI slot 6
64-bit
33 MHz (J55)
PCI hot-plug
switch card
(J1)
Chapter 2. Installing options
15