IBM Netfinity 6000R Installation Manual page 22

The following illustration shows the rerouting of the SCSI cable, if you install an IBM
ServeRAID® adapter.
ServeRAID adapter
To cable an IBM ServeRAID adapter:
10
IBM® Netfinity® 6000R Installation Guide
Plastic
dividers
SCSI connector
(J38)
1. Review the information in "Safety" on page v.
2. Turn off the server and disconnect all cables.
3. Remove adapters, plastic dividers, and the fan assembly from the server.
4. Disconnect the internal SCSI cable from the SCSI connector on the system board
and carefully thread the cable out of the chassis, pulling the cable out of the
opening in the chassis.
5. Reinstall the fan assembly, plastic dividers, and adapters.
Fan assembly
release latch