Table of Contents
Advertisement
STEP 4
Wire OHD Anywhere™: (Single door install shown)
OHD Anywhere™ will wire directly to the wall control connections at the powerhead or
directly to the wall control. New Genie models shown.
Visit www.OverheadDoor.com/OHDAnywhere for more information on older models
and other brands of garage door openers.
1.
Make sure garage door opener is unplugged.
•
Leave wire spool intact for this part of the install.
2.
Split provided dual strand wire approximately 2 in. then strip 1/2 in. of insulation.
FIG. A.
3.
Press orange tabs down and insert both wires into connection points for DOOR 1
on the back of the DCM. FIG. B.
4.
Trim and split the other end of the dual strand wire approximately 2 in. and then
strip 1/2 in. of insulation. FIG. A.
5.
Insert wire into wall control inputs either:
A) Directly to the garage door opener.
•
(OPTION
•
OR
B) To the Back of the wall control.
•
(OPTION
FIG.A
2"
Press tab down
to install wire.
1/2"
Split 2" & Strip 1/2"
Button & Connection Detail
Door
1
FIG. B
OVERHEAD DOOR CORPORATION
1-866-901-2750 or www.Overheaddoor.com
Door
Door
2
3
See
next
page
Hide quick links:
Advertisement
Table of Contents
