Table of Contents
Advertisement
Programming Information
TRAVEL LIMITS
WARNING
!
•
Make sure doorway is in full view and clear of obstacles and
people to avoid injury or property damage.
•
DO NOT operate this unit from the wall control before LIMITS
are set. Severe damage to the opener could occur.
•
The carriage MUST be engaged to bullet BEFORE setting
limits. See installation poster (if provided) or call Customer
Service at 1-800-929-3667 or visit www.overheaddoor.com.
•
AC power MUST be connected to the opener while setting
limits for proper operation.
NOTE: If bullet has NOT been engaged to carriage, do so now.
NOTE: Before setting limits confirm wall console red indicator
back light is ON. If not illuminated, check for correct wiring or the
Sure-Lock™ switch may be activated. (On selected models.)
Closing Garage Door (Down Limit)
NOTE:
Beginning with garage door in mid travel is recommended but not
necessary.
1. Lift door by hand until carriage engages the bullet on
the chain/belt.
Lever must be UP
READ AND UNDERSTAND STEPS 2-5 BEFORE
PROCEEDING
2. Press and hold the down arrow button (–) for two
seconds or until the long LED comes on blue. (The round
LED stays off.)
+
+
+
+
Steady Blue
–
–
–
3. Release down arrow button (–) and the long LED will
begin flashing blue. (Round LED still off.)
+
+
+
+
Flashing Blue
–
–
–
6
PRGM
PRGM
PRGM
SET
SET
SET
PRGM
PRGM
PRGM
SET
SET
SET
AVERTISSEMENT
!
•
S'assurer que le passage de la porte est visible et dégagé, à
savoir sans obstacles ni personne afin d'éviter toute blessure
potentielle ou dommage matériel.
•
NE PAS utiliser cette unité avec la console murale avant
d'avoir réglé les LIMITES. L'ouvre-porte pourrait subir de
sérieux dommages.
•
La navette DOIT être engagée dans le chariot AVANT de régler
les limites. Voir le poster d'installation (si fourni) ou appelez
le service clientèle au 1-800-929-3667 ou visitez le site
www.overheaddoor.com.
•
NE PAS fixer de limites en mode batterie de secours.
L'alimentation CA DOIT être branchée sur l'ouvre-porte,
pendant le réglage des limites, pour assurer un bon
fonctionnement.
4. Press and hold the down arrow button (–) to begin
closing the garage door. When the garage door is fully
closed, release the down button (–). If it has gone too far
press and release the up button (+) to move the door
up slightly. The door can be moved up or down with the
arrow buttons. The door should rest tightly on the floor.
5. Press and release the program/set button—both LEDs
flash blue and then go off.
The DOWN (CLOSED) TRAVEL LIMIT IS NOW PROGRAMMED.
+
+
+
+
Flashing
PRGM
PRGM
PRGM
Blue
–
–
–
+
+
+
SET
SET
SET
+
PRGM
PRGM
PRGM
–
–
–
SET
SET
SET
Advertisement
Table of Contents
