Measure Garage Door Height; Check Door Header Area - Overhead door PowewrMax XL 4060 Operation And Maintenance Manual

Dc powered screwdrive opener. with codedodger remotecontrol and series ii electronics
Table of Contents

Advertisement

Check Step 3:
Measure garage door height (7'-6", 8'-0", or taller) with
tape measure.
A
If door height is 7'-6" or less, continue with Check Step 4.
B
If door height is 8'-0", you need a Rail Extension
Kit. (Figure 3) (See Accessories Order Form, page 21).
C
If door height is taller than 8'-0", the door opener you
purchased is the wrong version. Contact an Overhead Door
Customer Service Representative at 1-800-784-5028.
Check Step 4:
The header is a heavily reinforced section of the wall just
above the top of the garage door opening.
A Find vertical center line of door and header:
Close door.
Measure door width at top.
Mark a point at center of door and on header directly
above door. Draw a center line to connect points.
B
Find Header Bracket mounting height (Figure 4):
(Do not attach Header Bracket).
Raise door, watching top edge of door and stop door
when its edge reaches its highest point.
Measure distance ("H") from top edge of door to floor.
For sectional doors, add 2-1/2" to "H" . Mark a point
on center line. Bottom of Header Bracket will be
installed here.
For one-piece doors, add 6" to "H" . Mark this point on
center line. Bottom of Header Bracket will be
installed here.
For both types of doors:
– If the ceiling in your garage is so low that there is
not at least a 3" space above the Header Bracket
mounting point, contact a Factory Authorized Dealer.
If a door spring is in the way, place the Header
Bracket avove the spring. Do Not move the door spring.
Door springs are under extremely high tension and should be
handled ONLY by a trained professional.
C
Check wall for a stud or a solid header at your mark:
(If checking a finished wall, a stud finder may be helpful).
If location is above Header, a 2" x 6" board must be
screwed to studs beside your mark with at least two Lag
Screws and Flat Washers (not provided).
Transfer your mark to new mounting board.
6
M
G
D
EASURE
ARAGE
OOR
C
D
H
HECK
OOR
EADER
NOTE
NOTE
WARNING:
H
EIGHT
A
REA
HEADER
HEADER
For Help, call 1-800-784-5028 or visit www.overheaddoor.com
Figure 3
Rail Extension Kit
SECTIONAL DOOR
ONE-PIECE DOOR
Figure 4
Find Highest Point of door travel
Rail Extension for
8' door

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents