Fx1 Programming (Vocal Mode) - Korg i40M User Manual

Page 20: FX1 programming (Vocal mode)
This page shows the parameters of the FX1 effect
selected in "Page 16: Vocal Effects (2) (Vocal mode)".
The parameters are different according to the selected
effect.
Note: These parameters can only be accessed if the FX1
parameter is not set on OFF in "Page 16: Vocal Effects (2)
(Vocal mode)".
Chorus
The chorus effect is a delay modulated by an LFO
(Low Frequency Oscillator) and produces a slight vari-
ance in pitch. When it is combined with the direct sig-
nal, an effect as though multiple instruments were
playing in unison is produced. The chorus effect
makes the sound wider and deeper.
MODE ARR.PLAY
CHORD
TEMPO
CHORUS
Speed=10 Depth=15
Note: The chorus effect will not be noticed if (1) if the
output signal is taken in mono or (2) the signal is taken in
stereo, but in the external mixer the pan of the two chan-
nels has the same setting. In order to notice it, the signal
must be taken in stereo and the pan sliders of the two
channels must be turned in the opposite direction.
Level
[0...30]
Chorus level.
Speed
[0...30]
Chorus speed modulation.
M 7
OCTAVE
Level=15
PAGE
Reference • Arrangement Play mode
Depth
[0...30]
Chorus intensity.
Delay
The delay sends the effected signal in feedback to the
input of the delay, thus creating repetitions of the orig-
inal note. Each repetition has a lower sound level than
the previous one until the sound dies away.
MODE ARR.PLAY
CHORD
TEMPO
DELAY Level=24
Time=21 F.Back=11
Level
[0...30]
Delay level.
Time
[0...30]
Delay time. It will determine the duration of each rep-
etition.
F.Back (FeedBack)
[0...30]
The feedback (return of the signal sent back in the
delay) will determine the number of repetitions.
M 7
OCTAVE
PAGE
69