Table of Contents
Advertisement
Getting Started • Operative modes
Disk/Global mode
The Disk/Global mode allows you to load or save
data, and modify the parameters which affect the
operation of the instrument. The operations you can
carry out are:
• Save on disk data contained in memory and load
into memory data from disk
• Tune the keyboard
• Modify MIDI settings
• Program pedals and external controllers
• Program Lower Memory
• Select a Scale (temperament)
• Control transmission/reception of MIDI messages
(data filtering)
Display pages
The parameters and functions of the various operative
modes are grouped into several pages, which appear
on the display. The page number is always indicated
on the right-hand side of the display. To move through
the display pages use the PAGE [+] and [–] buttons.
If you wish to go directly to a page number you know,
hold down the operative mode button the page which
you wish to go to belongs to and enter the number
using the buttons of the PROGRAM/ARRANG. sec-
tion.
To go directly to a page from 1 to 8, press the PRO-
GRAM/ARRANG button to light up the ARRANG led
and then press a NUMBER button from number [1] to
number [8].
To go directly to a page from 9 to 16, press the PRO-
GRAM/ARRANG button to light up the PROGRAM
led and then press a NUMBER button from number [1]
to number [8].
Recording a display page
When the instrument is new, pages from 1 to 8 are
assigned to the ARRANG + NUMBER button combi-
nation from number [1] to number [8], and the pages
from 9 to 16 are assigned to the PROGRAM + NUM-
18
• Calibrate the pedal/footswitch
• Program the MIDI channels of the VOCAL section.
Apart from the Local Control and Clock Source
parameters, all the settings (including the split point)
can be saved in Global (with the Write Global function,
see page 152) and will be retained when the instru-
ment is turned off.
Global can be saved on disk and will be saved with
each Save All and Save Global operation. The split
point is not saved or loaded.
Note: The i40M can read disks from other Korg i-Series
instruments, of which it can re-use the data (see
page 133).
BER button combination from number [1] to number
[8]. To record these pages under different numbers,
use the following procedure.
Access the display page that you wish to record.
1
Hold down the current operative mode button
2
and press the REC/WRITE/LYRICS button.
3
Release the REC/WRITE/LYRICS button (continue
pressing the operative mode button).
Press in sequence the button combination where
4
you want to record the current display page.
Press the PROGRAM/ARRANG button to light up
the PROGRAM or ARRANG led and then a NUM-
BER button from [1] to [8].
Release the operative mode button and the but-
5
ton that you have recorded.
You may find it convenient to record the same type
of page in the various operative modes to the same
button. For example, the effect selection page could
be found under the PROGRAM + NUMBER button
number [7] both in the Song Play and Arrangement
Play mode.
Advertisement
Table of Contents
