Hinge Adjustment - Viking Vcbb536rss Installation Manual

Hinge Adjustment

5
2
Remove four side screws and remove unit top.
7
1
Replace unit top. Replace four side screws.
8a
Wall
2 x 4
Refrigerator
Attach one 2x4 to wall stud (refer to dimensions page
for exact location).
40
6
Front of unit
1 3
Loosen the four hinge screws. Adjust door.
Retighten four hinge screws.
8b
Wall
2 x 4
Refrigerator
If needed, depending on cabinet and depth,
attach second 2x4 to first 2x4.
9
Plug in power cord to verify operation.
NOTE: Make sure power switch is in the "On" Position.
10b
Carefully move unit until semi flush with cabinet
(depending on unit).
12
Flush water line by running two quarts of water
into a bucket. Turn water off.
41
10a
Place unit within 3" of being flush with cabinets.
NOTE: To avoid cabinet damage, place cardboard
between cabinets and unit. When moving unit, do not
crimp, kink or crush water supply line.
11
Pull supply tubing forward under unit.
NOTE: DO NOT use plastic water lines.
13
Connect supply tube to water valve using
a 1/2" wrench. NOTE: DO NOT overtighten.