Installation - Viking Vcbb536rss Installation Manual

Side-by-side & bottom-mount refrigerator/freezer
Table of Contents

Advertisement

General Information
• Most of the unit's weight is at the top.
TIP OVER HAZARD
Extra care is needed when moving the unit
Appliance is top heavy and tips easily
to prevent tipping.
when not completely installed. Keep
doors closed until appliance is
• Do not remove protective film until unit is
completely installed and secured per
in operating position.
installation instructions. Use two or
• All four leveling legs must contact the floor
more people to move and install
to support and stabilize the full weight.
appliance. Failure to do so can result
in death or serious injury.
• Do not drop unit.
Unpacking Unit
• Remove exterior shipping materials prior
to moving unit into home, except door
1. Remove top and bottom strap.
latching device.
2. Remove top cap.
• Use two or more people to move and
3. Cut carton rear approximately 1/4"
install unit. Failure to follow this instruction
can result in back or other injury.
4. Remove carton and exterior packaging.
• To avoid personal injury, wear gloves when
performing any installation procedure and
wear eye protection when cutting metal
straps.
Moving Unit
Remove shipping brackets from skid by removing four
bolts (two on each side) with a 1/2" deep-well socket
wench and a pair of pliers.
NOTE: Tilting unit is not required to remove
shipping brackets.
38
(0.6 cm) to 1" (2.5 cm) from right corner
with a utility knife extended 1/4" (0.6 cm).
Save cardboard shipping material to
protect floor surface when installing unit.
Remove anti-tip board, kickplate and door
trim pieces (DF models) from rear of unit.
Slip appliance dolly between unit and skid. Remove
unit from skid.
NOTE: Use excess packaging to protect decorative
trim; also, verify that leveling legs are up (0"
adjustment).

Installation

1
Place unit in front of cutout.
2b
(Designer) Pull the center grille louver up
at an angle and pull out.
4
Remove grille assembly.
39
2a
(Professional) Lift center grille louver up
and pull out.
3
Using an 8" magnetic nut driver, remove
the two 1/4" screws.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents