Steps
c
Remove the left end. Hold the end of
connection rod with left hand, hold the
horizontal louver with right hand to
separate connection rod and horizontal
louver.
d
Remove the horizontal louver along the
axile center direction.
e
Note: (during operation, install the left
end and then install the right end. After
installation, re-energize the unit until the
horizontal louver is reset. After that, you
can operate the unit).
f
Remove 4 screws on front case and electric
box cover with screwdriver.
g
Remove electric box cover.
92
Procedure
screws
electric box cover
Installation and Maintenance
Service Manual