Starter Motor - CPI SuperMoto Series Service Manual

ELECTRICAL SYSTEM ES-11
FLYWHEEL COVER MOUNTING
Mount the gasket and the cover of the flywheel.
Verify the seat of the grommets.
Tighten the screws.
Torque: 1 2 Nm
Gasket
Cable grommet
Cover

STARTER MOTOR

REMOVAL
Remove the two screws below the left crankcase
and the fixing bolt at the rear part of the starter
motor.
INSTALLATION
Make sure that the O-ring is seated in the
provided groove. Apply a thin film of special oil
seal grease and secure the starter motor with the
fastening screws.
Torque: 5 Nm