Carburetor Removal - CPI SuperMoto Series Service Manual

CARBURETOR

CARBURETOR REMOVAL

Place a suitable container under the drain pipe of
the float chamber and open the drain screw.
Remove the hose clamp of the intake manifold.
Remove the connection to the suction hose.
Remove the fuel line, the carburetor heating, and
the oil lead.
Disconnect the choke cable plug from the wiring
harness.
The drained fuel must be properly
disposed.
Remove the carburetor (from the suction hose)
with the back end first.
Release the screws in the the carburetor cover and
remove the carburetor (the cover remains mounted
to the vehicle).
DISASSEMBLY
Release the fastening screws of the choke cable
support bracket and remove the choke cable.
Release the fastening screws of the float chamber
cover and remove the float chamber cover. Clean
any deposits or cloggings in the the float chamber
cover and bores.
Screw out the idle speed screw and the mixture
control screw. Make sure that all sealing rings and
washers are removed as well. If they remain in the
bores of the carburetor body, they might get lost
during the cleaning with compressed air.
The A/F mixture screw must be
carefully screwed in, otherwise the
seat might get damaged.
Fuel line
Carburetor
Oil lead
Clamp
Intake
manifold
Overflow hose
Choke cable
FL-6
Suction hose