Charging System - CPI SuperMoto Series Service Manual

ELECTRICAL SYSTEM ES-3

Charging System

Checking the charging voltage
The charging voltage directly is related to the
charge state of the battery. All measurings have
Voltmeter
therefore to be carried out when the battery is
fully charged. Since the high current consumption
of the starter motor (E starter) can damage the
measuring instrument during the engine start, the
instrument has only then to be connected when
the engine is already running.
-1
Desired value: 13,0–14,5 V at 6000 min
Generator (Stator)
The 6-pole plug-in connection of the generator is
located under the fuel tank. All measurings of the
wiring harness have always to be taken at the
plug-in connection that is remotest from the
component (see chapter GI).
System circuit diagram
Voltage regulator
Ignition coil
Ign. switch
Speedometer
CDI
Stator