Product Specifications - ROHO AGILITY Operation Manual

P AR TS D ETAIL CONTI N UE D
Cover Components Detail:
Cover with Foam Pad only
Foam Pad
Zipper
To order replacement parts: In the U.S.A., contact the ROHO Customer Service Department, call your product provider or visit
www.therohostore.com. Outside the U.S.A., contact your country's ROHO International distributor.
P RODU CT SPECIFICATI ON S*
Materials:
Cover:
Front Side: Polyester
Back Side: Polyurethane foam coated
nylon/polyurethane coated polyester
Flaps: Polyurethane-coated polyester
Lumbar Support Pad: Polyurethane
AGILITY complies with CAL 117, EN 1021-1 and EN 1021-2 flammability requirements.
Wheelchair Compatibility:
WARNINGS:
AGILITY is compatible with many wheelchairs that are angularly adjustable, recline or tilt and result in a back angle up to and
including 60 degrees. Beyond 60 degrees, AGILITY may not be an appropriate selection. Use with wheelchairs that angularly adjust,
recline or tilt to a back angle greater than 60 degrees may cause AGILITY to accidentally disconnect from the wheelchair, resulting
in a fall and the potential for serious injury. Consult a clinician to determine if AGILITY is compatible with the individual's wheelchair.
Rigidizer bars may pose a mounting challenge. See TROUBLESHOOTING. Make sure the rigidizer bar does not interfere with any of
the back cane hardware components.
Note: If the back cane brackets are installed on the front side of the back canes, there will be up to 1 in. (2.5 cm) of additional seat depth loss.
AGILITY is designed to be used with most wheelchairs that have back canes described in the BACK CANE BRACKET COMPATIBILITY chart.
AGILITY must be sized correctly to the wheelchair and may not fit every wheelchair. Consult with the provider or clinician providing your
equipment to determine if your wheelchair and back canes are compatible with AGILITY.
Back Cane Bracket
(Top View)
A
Standard
Fits Circular
Back Canes
-OR-
Foam Pad
Handle
Cover
Cutout area
for air insert
or foam
insert
Fastener
Strip
Handle
*Note: The air insert and the foam insert are not intended to be used together.
Foam Pad:
Front Side: Polyurethane
Back Side: Polyethylene
Foam Insert: Polyurethane
Air Insert:
Front Side: Polyether polyurethane
Back Side: Urethane film coated nylon
BACK CANE BRACKET COMPATIBILITY
Adjusts to Fit Back Cane Diameters (A)
in.
A
0.75
Cover with Foam Pad + Air Insert or Foam Insert*
Air Insert
Valve Hose
Back Shell: Aluminum
Back Shell Hardware: Zytel
Back Cane Hardware:
Smallest
(cm) in.
(2.0) 1.0
- 5 -
Foam Insert
-OR-
Zipper
®
Sliding Height Adjustment Bar: Aluminum
Back Cane Bracket: Aluminum
Pivoting Cane Band and Adjustment
Cylinder: Steel
Largest
(cm)
(2.5)
*NOTE: All measurements are approximate.
Handle
Cover
Handle