Panel Filter Replacement; Intake Filter Replacement - Hertz HGS 2-15 Operator's Handbook Manual

PANEL FILTER REPLACEMENT

Panel filter keeps the dust trying to go inside the compressor. Filter change depends on
o
the ambient conditions and maintenance but should be changed every 2000 hours or 6
months
To change the panel filter;
After switching off the compressor remove the screws connecting the top perforate to
suction cowling.
Remove the old panel filter, replace the new filter in the same direction (due to its structure;
the panel filter' upper side is loose and the bottom side is tight).
Tighten the screws connecting the top perforate to the suction cowling.

INTAKE FILTER REPLACEMENT

Intake filter keeps the thin dust inside the suction air. Filter change depends on the
o
ambient conditions and maintenance but should be changed every 2000 hours or 6
months
- BELT DRIVEN MODELS
For replacing the intake filter;
Switch off the compressor. By removing the nut that is tightening the filter top cover,
remove the top cover and filters.
Clean the inner surface of the filter bottom cover with a cloth. Do not clean the dirt by
compressed air (it may go inside the intake valve).
Replace the new filter and close the top cover and make sure that filter is properly oriented
between the covers.
Mount the nut and washer of top cover.
If you will keep the filter in your stock preserve it in a clean place or its case.
- DIRECT DRIVEN MODELS
19