Hertz HGS 2-15 Operator's Handbook Manual page 32

ALARM CODES
CODE DESCRIPTION
SETTING DATA LOST, (LOADING FACTORY DEFAULTS)
PHASE FAULT
MAIN MOTOR OVERLOADED (RESET OVERLOAD SWITCH IN ELECTRIC BOX)
HIGH WORKING TEMPERATURE (SCREW TEMP. HIGHER THAN
FOREWARNING HIGH TEMPERATURE (SCREW TEMP. HIGHER THAN
WITH AUTOMATICALLY RESET AS SOON AS THE TEMPERATURE DECREASES
TEMPERATURE SENSOR IS DEFECTIVE
LOW TEMPERATURE (TEMPERATURE LOWER THAN
LOW POWER SUPPLY
THE COMPRESSOR WILL NEVER STOP 1 HOUR FROM THE FRIST START; IT WILL RUN
LOAD/UPLOAD ACCORDING THE PRESSURE (WITHIN A 1 HOUR,
SET VALUE.)
SECURITY PRESSURE SWITCH OPENED
PRESSURE OVER SET P03
PRESSURE TRANSDUCER / PRESSURE SWITCH FAILURE
EMERGENCY STOP BUTTON PUSHED
FOR RESETTING ALARMS PRESS
CHANGE AIR FILTER
CHANGE OIL FILTER
CHANGE SEPARATOR
CHANGE OIL
(FIXED) COMPRESSOR STOPPED / STAND-BY
(BLINKING) COMPRESSOR WAITING FOR STOP TIMER
-2°C
.
29
)
),
)
REACHED