Suggestions; Air Receiver - Hertz HGS 2-15 Operator's Handbook Manual

1.10 SUGGESTIONS

After repair, maintenance and adjustment works make sure that there is not any spare part,
cleaning material or hand tool are left inside.
Make sure that all the guards are installed after repair, maintenance or adjustment works.
Make sure that none of the moving parts are in contact with any component.
Do not leave unplugged electric conducting cables.
If the compressor will not be used for a long time; it should be stored at dry and warm
environment. The oil in the oil tank should be discharged and the screw unit has to be
lubricated with a protective lubricant against corrosion. If the compressor have belt driving the
belts must be removed or completely loosened.

1.11 AIR RECEIVER

Air receivers are to collect air, do not use for any other purposes. Do not exceed the pressure
value indicated on the name plate.
The floor on which the compressor is mounted should be capable of carrying the weight of
compressor and should be flat.
Technical specifications of the receiver are written on the name plate
Water must be discharged from the valve beneath the receiver for daily maintenance
Without any written approval of the factory, do not make any welding on the receiver
Do not make any cutting and piercing on the receiver
The designed value of corrosion tolerance is 0,5 mm
The receivers were tested up to 1,5 times the working pressure
According to regional regulations every year pressure test must be done to check the air
receiver. Please consult your local distributor or technical service
Welding points should be checked by eye regularly. If any extraordinary point is seen inform
the distributor immediately
During the maintenances avoid any impact and operation that will damage the receiver.
5