Hertz HGS 2-15 Operator's Handbook Manual page 30

USING THIS MANUAL
WHEN YOU SEE DISPLAY ADVANCE VIA BUTTONS ON THE RIGHT.
screen
1
USING THIS MANUAL : WHEN YOU SEE DISPLAY ADVANCE VIA BUTTONS ON THE RIGHT.
PRESS SIMULTANEOUSLY TO THE FRAMED BUTTONS.
FIRST PRESS LEFT-HAND SIDE BUTTON SIMULTANEOUSLY PRESS THE OTHER
ONE.
PRESS ONE AFTER ANOTHER
AFTER PRESSING THE MENTIONED BUTTONS, COMPARE THE DISPLAY WITH THE MANUAL
TO VERIFY. SO YOU CAN ADVANCE STEP BY STEP.
ALSO NOT TO CONFUSE STEP NO IS WRITTEN ON THE LEFT SIDE OF THE DISPLAY.
MAINTENANCE COUNTERS
WHEN THE COMPRESSOR IS RUNNING, PUSHING
MAINTENANCE TIMERS.
1 (WORKING PRESSURE)
2 (WORKING TEMPERATURE)
3
4
5
6
7
8 (RUNNING SCREEN)
IF THE NUMBERS TO BE DISPLAYED HAVE MORE THAN THREE (3) DIGITS OR TWO DIGITS
WITH NEGATIVE SIGN (-), THE MULTIPLICATIVE FACTOR LED "X10" OR "X100" EMMITING.
WHEN THE TIMERS ARE OVER, THEY WILL GO ON AS NEGATIVE COUNTING.
(1800 HOURS, SHOWING ON THE SCREEN
IF NO ONE BUTTON IS PUSHED FOR THE NEXT 1 MINUTE, CONTROLLER GOES MAIN
SCREEN AUTOMATICALLY.
WORKING HOUR COUNTERS
WHEN THE COMPRESSOR IS RUNNING, PUSHING
HOURS.
1 (WORKING PRESSURE)
2
3
4 (RUNNING SCREEN)
HOURS TO THE NEXT AIR FILTER CHANGE.
HOURS TO THE NEXT OIL FILTER CHANGE.
HOURS TO THE NEXT SEPARATOR CHANGE.
HOURS TO THE NEXT OIL CHANGE.
CHECK KOMPRESSOR
(TOTAL HOURS) AND THEN THE TOTAL HOURS VALUE
(LOAD HOURS) AND THEN THE LOAD HOURS VALUE
SHORTLY, THE DISPLAY SHOWS
AND WITH "X10" LED EMMITING)
THE DISPLAY SHOWS WORKING
27