Toyota PRIUS 2007 Important Information Manual page 331

6. Repeat steps 2 through 5 for each re-
maining HomeLink R button to program
another device.
Programming a rolling code system
If your device is "Rolling
equipped, it is necessary to
steps 1 through 4 under the heading
"Programming the HomeLink R
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener. Refer to the owner's
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle's pro-
grammed HomeLink R button twice. The
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
motor should
HomeLink R unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 each remain-
Code"
ing HomeLink R
follow
another rolling code system.
" before Programming an entrance gate/Program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand−held
transmitter 25 to 75 mm (1 to 3 in.)
away from the
HomeLink R .
Keep the indicator light on the HomeLink
in view while programming.
3. Press and
HomeLink R button.
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator
HomeLink R changes from a slow to a
rapid flash, you can release both but-
tons.
6. Test the operation of the HomeLink
now recognize the pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
button to program maining HomeLink
another device.
Programming other devices
To program other devices such as home
R but- security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
gate/device
Reprogramming a button
surface of the
Individual HomeLink
erased, however, to reprogram a single
R button, follow the procedure "Programming
the HomeLink
hold the selected (b) Operating the HomeLink
To operate the HomeLink
propriate HomeLink
programmed device. The HomeLink
cator
HomeLink
for up to 20 seconds as long as the but-
light on the
ton is pressed.
R
R button to program
R buttons cannot be
R ".
R
R , press the ap-
R button to activate the
R indi-
light should come on. The
R continues to send the signal
311
by