Toyota PRIUS 2007 Important Information Manual page 174

Connect the equipment into an outlet
D
on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced
D
radio/TV technician for help.
FCC WARNING:
Changes or modifications
pressly approved by the party respon-
sible for compliance could void the
user's authority to operate the equip-
ment.
For vehicles sold in Canada
Operation is subject to the following two
conditions:
(1) this device may not cause interfer-
ence, and (2) this device must accept
any interference, including interference
that may cause undesired operation of
the device.
154
REPLACING TIRES AND WHEELS
When replacing the tires and wheels, be
sure to install tire pressure warning valves
and transmitters. ID codes on the tire
pressure warning valves and transmitters
are registered on the tire pressure warning
ECU. When replacing
warning valve and transmitter, it is neces-
not ex-
sary to register the ID code of tire pres-
sure warning valve and transmitter. Have
the ID code registered by your Toyota
dealer.
If the ID code is not registered, the sys-
tem will not work properly. After about 1
hour, the tire pressure
comes on after blinking for 1 minute to
indicate a system malfunction.
NOTICE
When the tires or tire pressure warn-
ing valves and transmitters must be
replaced, have them replaced by your
Toyota dealer. The tire pressure warn-
ing valves and transmitters will be
affected by the installation or removal
of tires.
Tire pressure warning reset switch
a tire pressure
25p122
warning light
When initializing the system, the present
tire inflation pressure is stored as stan-
dard. The tire pressure warning system
determines
comparing the present and the standard
tire inflation pressures. When you change
the set tire inflation pressure, it is neces-
sary to initialize the tire pressure warning
system.
When rotating the tires on vehicles dif-
D
fering with front and rear tire inflation
pressures.
When changing the tire size.
D
decreased air pressure by