Garage door opener
Indicator light
28p128
Buttons
The garage door opener (HomeLink
Universal Transceiver) is manufactured
under license from HomeLink
R
be
programmed
to
operate
doors, gates, entry doors, door locks,
home lighting systems, and security
systems, etc.
(a) Programing the HomeLink
The HomeLink
R
in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programing into the
HomeLink
R
, install a new battery in the
hand−held transmitter prior to program-
ming.
The battery side of the hand−held trans-
mitter must be pointed away from the
HomeLink
R
during the programming pro-
cess.
For Canadian users, follow the procedure
R
in "Programming an entrance gate/Pro-
gramming all devices in the Canadian
and can
market".
garage
R
When the programming the HomeLink
the
first
time,
memory once before following the steps
below to program the HomeLink
"(c)
Erasing
the
memory" on page 312. When carrying out
(c), do not hold the buttons for longer
than 30 seconds.)
When registering the second and third sig-
nals, simply follow the steps listed below.
If
you
erase
the
again, any signals registered previously
will be erased.
1. Decide which of 3 HomeLink
you want to program.
R
for
erase
the
HomeLink
R
R
. (See
entire
HomeLink
R
HomeLink
R
memory
R
buttons
309