Calibrate; Calibrate In The Wifi Mode - Mustek H410W User Manual

Calibrate

NOTES
• Always clean the Scanner's rollers and lens first before
calibration. If cleaning rollers and lens did not improve
image quality, then please perform calibration procedures.
• If necessary, perform calibration few times until the image
quality is improved.
• Make sure the Calibration Sheet is clean and free of dust
before use.
• Mechanical sounds produced during the calibrating process
are normal.

Calibrate in the WiFi Mode

1. Slide the WiFi/Micro SD switch to "WiFi" and
connect to wireless network. (See p.12)
2. Press iScanAir Go app on your device to open it.
3. Find the Settings icon or Menu button on your
device to enter, then select the Calibrate.
Remove the plastic foil on the Calibration Sheet,
4.
place it on the table with the white side facing up.
5. Place the scanner on the Calibration Sheet, then
move it back and forth only in the white area few
times until the "Calibration Done" message appears.
(continued on the next page)
Select Calibrate from the Settings menu.
17