Diagnostic-Ping/Tracert; Ping - KTI Networks KWG-400 User Manual

11g Wireless Security Router User Guide

5-6 Diagnostic-Ping/Tracert

This function allows you to test the connection between router and LAN or between
router and Internet.

Ping

Source IP:
Destination IP:
Packet Number:
Packet Size:
Time Between
Time out:
Note that don't power off the router during the firmware
upgrading, otherwise the incompletion of firmware upgrading
will cause serious damage to the integrity of the router's
firmware that will lead to fail to boot the router again.
You can chose to issue the ping test from the LAN side by
selecting Router's private IP Address or from the WAN side
by selecting Router's WAN IP Address.
Enter the IP Address of destination device you want to ping. If
Router's LAN IP address is selected as Source IP, you only
can ping LAN side device and vice versa.
Enter the packet numbers you wish to use to ping the
destination device. The maximum numbers are four.
Enter the numbers of packet size you wish to use to ping the
destination device. The maximum packet sizes are 1514.
Enter the numbers of time between two packets.
Enter the number of time regarding as no response after
starting to ping the destination device.
- 57 -