Chapter 2: Hardware Installation & Setup; Rear Panel & Connections; Front Panel Leds - KTI Networks KWG-400 User Manual

11g Wireless Security Router User Guide
Chapter 2: Hardware Installation & Setup
This chapter provides information about your Advanced Wireless 11g Router's physical
features and gives step-by-step installation instructions.
2-1 Rear Panel & Connections
The following figure shows the rear view of the Advanced Wireless 11g Router and
illustrates how the cables connect to the interfaces on the rear panel.
1. Plug one end of the UTP cable into the WAN port, the other into the RJ45
Ethernet jack on your ADSL or Cable modem.
2. Connect a PC, which must have an Ethernet NIC (Network Interface Card)
installed, to one of the LAN Ports.
3. Connect the external power supply to the Advanced Wireless 11g Router.
4. The Reset button is used to reboot and re- initialize the device (press once quickly),
or for clearing configuration settings back to factory default values (press for
longer than 3 seconds).

2-2 Front Panel LEDs

The following figure shows the front view of the Advanced Wireless 11g Router.
The LEDs on the front panel indicate the status of the unit. You can easily view the
operation of your Advanced Wireless 11g Router from this panel.
- 6 -