Shown - ProForm Pro 2500 PFTL14011.1 User Manual

4. Hold the Left Upright (90) against the Base
(105). Be careful not to pinch the wires. If
necessary, position the base ground wire (A)
in the hole in the side of the Left Upright. Insert
two 3/8" x 2 3/4" Screws (8) and two 3/8" x 1
1/4" Screws (9) with two 3/8" Star Washers (14)
into the Left Upright.
Partially tighten the 3/8" x 2 3/4" Screws (8) and
the 3/8" x 1 1/4" Screws (9) until the heads of the
Screws touch the Left Upright (90); do not fully
tighten the Screws yet. Note: It may be help-
ful to use the Short Hex Key (43) on the Screw

shown.

Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the right
side.
5. Identify the Left and Right Base Covers (96, 97).
Slide the Left Base Cover (96) onto the Left
Upright (90). Slide the Right Base Cover (97)
onto the Right Upright (99). Do not press the
Base Covers into place yet.
4
90
8
Hole
14
A
9
14
5
90
96
9
43
105
99
97