ProForm Pro 2500 PFTL14011.1 User Manual page 12

12. With the help of a second person, hold the con-
sole assembly near the Uprights (90, 99).
Connect the Upright Wire (88) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Next, connect the two pulse wires. Then, remove
the wire tie from the Upright Wire (88).
13. Insert the pulse wires and the Upright Wire (not
shown) into the Handrails (92, 93) as you set the
console assembly on the Handrails.
Attach the console assembly with four 5/16" x
5/8" Screws (4) and four 5/16" Star Washers
(12). Start all four Screws, and then tighten
them.
Tighten the four 3/8" x 1" Screws (6).
12
Pulse Wires
Pulse Bar
Assembly
99
13
93
12
6
4
12
Console
Assembly
88
Console
Wire
90
Wire
Tie
Console
Wire
88
12
Console
Assembly
4
92
6