Powering Off The Projector; Warning Indicator - InFocus IN226ST User Manual

Installation
Contact the
nearest service
center if the
projector displays
these symptoms.
16
English

Powering off the projector

1. Press the " " button on the remote control or on the
control panel to turn off the projector.
The following message will be displayed on the screen.
Press the " " button again to confirm otherwise the
message will disappear after 15 seconds. When you press-
ing for the second time, the projector will shut down.
2. The cooling fans continue to operate for about 10 seconds
for cooling cycle and the ON/STANDBY LED will Flash
Green. When the ON/STANDBY LED lights solid Amber,
the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until
the projector has completed the cooling cycle and has en-
tered standby mode. Once in standby mode, simply press "
" button to restart the projector.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.

Warning Indicator

When the warning indicators (see below) come on, the
projector will automatically shutdown:
"LAMP" LED indicator is lit red and if "On/Standby" indicator
flashes amber.
"TEMP" LED indicator is lit red and if "On/Standby"
indicator flashes amber. This indicates the projector has
overheated. Under normal conditions, the projector can be
switched back on.
"TEMP" LED indicator flashes red and if "On/Standby"
indicator flashes amber.
Unplug the power cord from the projector, wait for 30 seconds
and try again. If the warning indicator light up again, please
contact your nearest service center for assistance.