Test Procedures; Index Of Test Procedures; Page 11-18 2000 Fe290 Gasoline Vehicle Maintenance And Service Supplement - Club Car FE290 Maintenance Service Supplement

11
TROUBLESHOOTING

TEST PROCEDURES

INDEX OF TEST PROCEDURES

1. Fuse
2. Battery
3. Ground Straps
4. Key Switch (Starter Circuit)
5. Accelerator Pedal Limit Switch
6. Solenoid
7. Neutral Lockout Limit Switch
8. Starter/Generator (Starter Function)
9. Wire Continuity
10. Starter/Generator (Generator Function)
11. Voltage Regulator
12. Disconnected Kill Wire
13. Ignition Spark
14. RPM Limiter
15. Ignition Coil
16. Kill Limit Switch
17. Key Switch (Engine Kill Circuit)
18. Engine Kill Wire
19. Reverse Buzzer Limit Switch
20. Reverse Buzzer
21. Oil Level Sensor
22. Oil Warning Light
23. Neutral Lockout Cam
24. Battery Test (Under Load)
25. Fuel Level Sending Unit
26. Fuel Gauge
27. Hour Meter
TEST PROCEDURE 1 – FUSE
Read DANGER and WARNING on page 11-1.
The fuse (red 10 amp) is located in the electrical component box.
1. Place the neutral lockout cam in the SERVICE position, put the Forward/Reverse handle in the
NEUTRAL position, chock the wheels, and disconnect the battery (negative cable first).
2. Remove the cover on the electrical component box.
3. Check that the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
4. Remove the fuse to be tested from the fuse block. See Fuse Removal, Section 12 – Electrical
Components, Page 12-15.
5. Using a multimeter set on 200 Ω (ohms), place the red (+) probe on one fuse terminal and the black (–)
probe on the other fuse terminal. The reading should be continuity. If the reading is incorrect, determine
and repair the cause of the fuse failure. Replace the fuse with a properly rated new one.

Page 11-18 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement

Test Procedures