Event triggered
recording controlled
by motion
detection
5.2 Log File
Vista SmartDisc 10IP
With this method, the event-controlled recording is triggered using the
integrated motion detection on analogue cameras with adjustable sensitivity
and optional definable detection areas.
This pre-alarm sequence
is recorded
Motion is detected
Start
Interval
Pre-alarm
Illustration: Event recording triggered by integrated motion detection
SmartDisc
10IP protocols, important device states and events in a log file
with a capacity of up to 1,000 entries. The oldest entries will be overwritten
automatically according to
removable hard disk. It can by displayed by SmartControl and
SmartControl
PRO software in online mode, or also in offline mode by
SmartPlayer
software. Certain log file entries are system entries and as such
beyond the control of the user. Other messages are optional and must be
defined with SmartControl or
Extras in Site
archive. In the table below these messages are marked yes in
column Optional. Critical messages are indirectly connected to the error
relay and marked yes in column Error
Column Log file
entry provides the text messages and optional additional
information indicated by square brackets. Additional information date and
time apply to all entries. Therefore each Log file entry
all other additional information, letters (e.g. [x]) are used, which are explained
in column Description.
5 Description of "Site archive" features
This post-alarm sequence
This pre-alarm sequence
is recorded
Motion is detected
Alarm picture
Interval
Interval
Post-alarm
First In First
Out. The file is stored on the
SmartControl PRO
relay.
This post-alarm sequence
is recorded
is recorded
Alarm picture
Start
Interval
Pre-alarm
Post-alarm
software with menu
starts with [D&T]. For
47