Crankshaft Disassembly - Mercury 30 Service Manual

NOTE: Refer to appropriate sections in service
manual for removal of individual fuel and electrical
sub-assemblies from powerhead.
Component/Assembly
Starter Motor
Ignition Switch Box
Ignition Coil
Starter Solenoid
Voltage Regulator/Rectifier
Flywheel
Stator Assembly
Trigger Assembly
Air Silencer
Carburetor and Linkage
Fuel Pump
Fuel Enrichment Valve
Shift Cable Latch Assembly
Control Cable Anchor Bracket
Warning Module
Oil Pump
*NOTE: All ignition and electrical components can be
removed and installed as an assembly.
4-12 - POWERHEAD

Crankshaft Disassembly

1. Remove center main bearing.
Section
2B
2A*
2A*
2B*
2B*
2A
2A*
2A*
3B
3B
3A
3B
7A
2. Remove rod cap bolts and keep components with
respective connecting rod. Reattach caps to re-
7A
spective rod as each piston/rod assembly is re-
3C*
moved. CAPS MUST BE INSTALLED IN SAME
3C
DIRECTION ON SAME ROD or BEARING
FAILURE WILL RESULT.
3. Remove main bearing sealing ring.
52906
52907
52908
90-826148R2 MARCH 1997