Using The Remote - Sony MHC-NX300AV Operating Instructions Manual

9
Connect the mains lead to a wall
outlet.
The demonstration appears in the
display. When you press ?/1, the
system turns on and the demonstration
automatically ends.
If the supplied adapter on the plug does
not fit your wall outlet, detach it from
the plug (only for models equipped with
an adapter).
To connect optional components
See page 52.
To deactivate the demonstration
When you set the time ("Step 3: Setting the
time" on page 10), the demonstration is
deactivated.
To activate/deactivate the demonstration
again, press DEMO (STANDBY) while the
system is off.
Tip
You can reinforce the bass sound by connecting an
optional super woofer to the super woofer connector.
To attach the speaker pads
Attach the supplied speaker pads to the
bottom of the speakers to stabilize the
speakers and prevent them from slipping.
Use the large speaker pads for the front
speakers, and the small speaker pads for the
centre and rear speakers.
Inserting two size AA (R6)
batteries into the remote

Using the remote

You can use the shaded buttons shown below
to operate a Sony TV.
TV/VIDEO
To
Turn the TV on or
off
Switch the TV's
video input
Change the TV
channels
Adjusts the volume
of the TV speaker(s)
Tip
With normal use, the batteries should last for about
six months. When the remote no longer operates
the system, replace both batteries with new ones.
Note
If you do not use the remote for a long period of
time, remove the batteries to avoid possible damage
from battery leakage.
When carrying this system
Do the following to protect the CD
mechanism.
Make sure that all discs are removed from the
unit.
1 Press CD (or FUNCTION on the remote
repeatedly) until "CD" appears in the
display.
2 Hold down ENTER and press ?/1 so that
"LOCK" appears in the display.
3 Disconnect the mains lead.
TV
TV VOL +/
TV CH +/
Press
TV ?/1.
TV/VIDEO.
TV CH +/–.
TV VOL +/–.
7