Timer-Recording Radio Programmes - Sony MHC-NX300AV Operating Instructions Manual

Timer-recording radio
programmes
To timer-record, you must preset the radio
station (see "Step 4: Presetting radio
stations") and set the clock (see "Step 3:
Setting the time") beforehand.
2
V
3,4
B
v
1
Tune in the preset radio station (see
"Listening to the radio" on page 18).
2
Press CLOCK/TIMER.
"SET (DAILY 1)" appears.
3
Press V or v repeatedly to select
"REC", then press ENTER.
"ON" appears and the hour indication
flashes in the display.
7
TIMER
SELECT
3,4
b
REC
4
Set the time to start recording.
Press V or v repeatedly to set the hour,
then press ENTER.
The minute indication starts flashing.
Press V or v repeatedly to set the minute,
then press ENTER.
The hour indication flashes again.
5
Set the time to stop recording
following the above procedure.
The recording source, followed by the
start time, the stop time and the radio
station appear, then the original display
appears.
6
Insert a recordable tape into deck B.
7
Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and press V or v
repeatedly to select "REC", then press
ENTER. To change the setting, start over from
step 1.
To cancel the timer operation
Press TIMER SELECT and press V or v
repeatedly to select "TIMER OFF", then press
ENTER.
Note
If the power is on at the preset time, the recording
will not be made.
REC
51