Connecting The Wire To The Headlight; Filling The Engine With Oil - Toro Power Max 1128 OXE 38828 Operator's Manual

7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Wire to the
Headlight
Parts needed for this procedure:
1 Cable tie
Procedure
1. Insert the wire connector on the loose end of the wire
straight into the back of the headlight until it is securely
in place (Figure 17).
Figure 17
1. Plastic clip on wire
connector
2. U-bolt
Note: Ensure that the plastic clip on the wire
connector is on the bottom (Figure 17).
2. Secure a cable tie (from the loose parts bag) around the
wire and the handle about an inch (2.5 cm) below the
U-bolt (Figure 17).
3. Cable tie
6

Filling the Engine with Oil

No Parts Required
Procedure
Your machine comes with oil in the engine crankcase.
Note: Before starting the engine, check the oil level and
add oil if necessary.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher. Refer to your engine owner's
manual.
Use Figure 18 below to select the best oil viscosity for the
outdoor temperature range expected:
1. Using SAE 30 at outdoor
temperatures below 40°F
(4°C) will result in hard
starting.
Engine Oil Capacity
Model
38828
1. Remove the dipstick and slowly pour oil into the
oil fill tube to raise the oil level to the Full mark on
the dipstick. Do not overfill (Figure 19). Refer to
Checking the Engine Oil Level in Maintenance.
11
Figure 18
2. Using 10W-30 at outdoor
temperatures above
80°F (27°C) may result in
increased oil consumption;
therefore, check the oil
level more frequently in
these circumstances.
Engine Oil Capacity
26 to 28 oz. (0.77 to 0.83 l)