Adjusting The Discharge Chute Latch - Toro Power Max 1128 OXE 38828 Operator's Manual

1. Using SAE 30 at outdoor
temperatures below 40°F
(4°C) will result in hard
starting.
Engine Oil Capacity
Model
38828
1. Clean the area around the oil drain cap (Figure 48).
1. Oil drain cap
2. Slide an oil drain pan under the drain extension and
remove the oil drain cap.
3. Drain the oil.
Note: Dispose of the used oil properly at a local
recycling center.
4. Install the oil drain cap.
5. Fill the crankcase with oil. Refer to Filling the Engine
Crankcase with Oil.
Figure 47
2. Using 10W-30 at outdoor
temperatures above
80°F (27°C) may result in
increased oil consumption;
therefore, check the oil
level more frequently in
these circumstances.
Engine Oil Capacity
26 to 28 oz. (0.77 to 0.83 l)
Figure 48
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired position
or does not unlock so that you can move it to another
position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 49), lift
the front of the cover up, and slide it back and out of
the way.
2. Loosen the bolt on the cable clamp (Figure 50).
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 50 and Figure 51).
1. Discharge chute latch
23
Figure 49
Figure 50
2. Cable clamp
Figure 51
2. Gear teeth