Product Overview - Toro Power Max 1128 OXE 38828 Operator's Manual

The machine should move forward. If the machine
does not move or moves rearward, complete the
following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 11).
C. Turn the trunnion upward (counterclockwise) on
the speed control rod (Figure 11).
D. Connect the trunnion to the speed selector lever
(Figure 11).
7. If you made any adjustments, repeat this procedure
until no adjustments are required.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable) or
take the machine to an Authorized Service Dealer for
service.

Product Overview

1. Hand-grip (2)
2. Auger/impeller lever
3. Speed selector lever
4. Quick Stick™ discharge
chute control
5. Traction lever
6. Fuel tank cap
7. Engine oil fill tube/dipstick 16. Headlight
8. Chute deflector
9. Discharge chute
1. Choke
2. Ignition switch
3. Fuel shutoff valve
4. Throttle
13
Figure 21
10. Scraper
11. Auger
12. Skid (2)
13. Electric starter button
14. Electric starter plug
15. Snow cleanout tool
17. Wheel clutch lever (2)
Figure 22
5. Recoil starter
6. Oil drain plug
7. Primer