Fanimation distinction A1 series Owner's Manual page 8

How to Assemble Your Ceiling Fan (Downrod)-continued
4. Route the 80 in. wires through canopy trim ring
assembly, motor coupling cover assembly and
ceiling canopy. (Figure 4)
5. Reinstall the hanger ball on the downrod as
follows. Route the 80 in. wires through the hanger
ball. Position the pin through the two holes in the
downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger
ball. A loose set screw could create fan wobble.
(Figure 5)
6. Cut off excess lead wire approximately 6 to 9
inches above top of the downrod. Strip
insulation off 1/2 inch from the end of each lead
wire. (Figure 6)
NOTE: All set screws must be checked, and
retightened where necessary, before installation.
7. Completely remove one of each right-hand screw
on either side of the flap of the hanger bracket and
retain the screws for later. Loosen the remaining
screws without fully removing them. (Figure 7)
Motor Coupling
Cover Assembly
Standard Hanger Ball
8
Canopy
Canopy Trim Ring
Assembly
Figure 4
Sloped Hanger Ball
Figure 5
Figure 6
Figure 7