Changing The Settings Of This Unit Using The Settings Utility; Displaying Setting Utility; Checking Status Of Input Select Switches; Setting Audio Data Output To Computer - Pioneer DJM-S9 Operating Instructions Manual

Changing the settings of this unit using the settings utility

The setting utility can be used to make the checks and settings
described below.
— Checking the status of this unit's [INPUT SELECT] switches
— Setting the audio data output from this unit to the computer
— Adjusting the buffer size (when using Windows ASIO)
— Checking the version of the firmware and driver software
— Changing the effect type of BEAT FX
— Changing the function settings for DJM-S9
Displaying the setting utility
For Windows
Click [Start] menu > [All Programs] > [Pioneer] > [DJM-S9] > [DJM-
S9 Settings Utility].
For Mac OS X
Click [Macintosh HD] icon > [Application] > [Pioneer] > [DJM-S9] >
[DJM-S9 Settings Utility].
Checking the status of this
unit's [INPUT SELECT] switches
Display the setting utility before starting.
Click the [MIXER INPUT] tab.
Setting the audio data output from this
unit to the computer
When Serato DJ is running and using this unit as the default audio
device, set the audio data output in Serato DJ.
Display the setting utility before starting.
1 Click the [MIXER OUTPUT] tab.
2 Click the [Mixer Audio Output] pull-down menu.
Select and set the audio data to be output to the computer from the flow
of audio signals inside this unit.
CH1 CH2
CH1 Control Tone CH2 Control Tone
1 1
PHONO PHONO
CH1 Control Tone CH2 Control Tone
1 1
CD/LINE CD/LINE
2
Post CH1 Fader Post CH2 Fader
23 23
Cross Fader A Cross Fader A
23 23
Cross Fader B Cross Fader B
MIC MIC
AUX AUX
1 The audio data is output with the same volume at which it is input to this unit,
regardless of the [USB Output Level] setting.
2 When using for applications other than recording, pay attention to the DJ
application's settings so that no audio loops are generated. If audio loops are
generated, sound may be input or output at unintended volumes.
3 The sound which the [ECHO], [DELAY] and [SPIRAL] effects are applied to is
output from [Cross Fader A] or [Cross Fader B].
4 The sound which the [REVERB] effect is applied to is only output from [MIX (REC
OUT)].
3 Click the [USB Output Level] pull-down menu.
Adjust the volume of the audio data output from this unit.
! The [USB Output Level] setting is applied equally to all audio data.
However, when 1 on the table at step 2 is selected, the audio data is
output with the same volume at which it is input to this unit.
! If not enough volume can be achieved with the DJ software's volume
adjustment alone, change the [USB Output Level] setting to adjust
the volume of the audio data output from this unit. Note that the
sound will be distorted if the volume is raised too high.
Adjusting the buffer size (when using
Windows ASIO)
If an application using this unit as the default audio device (DJ software,
etc.) is running, quit that application before adjusting the buffer size.
Display the setting utility before starting.
CH3 CH4
MIX (REC
FX SEND
24
OUT)
23
Cross Fader A —
2 23
Cross Fader B —
MIC —
AUX —
2
Post CH1 Fader —
2
Post CH2 Fader —
33
En