Notes On Various Settings When The Unit Are Replaced - Pioneer SVM-1000 Service Manual

5

6.8 NOTES ON VARIOUS SETTINGS WHEN THE UNIT ARE REPLACED

Notes
1 When the MAIN unit is replaced
Depending on the level of failure, if the user settings are obtainable before replacement, make note of them, as
mentioned in 1 above, then make the same settings after replacement.
Then perform calibration of the Touch Panel and set the video system according to the destination.
2 If the Touch panel or LCD panel is replaced, perform calibration of the Touch panel in Service mode.
Factory setting
The factory settings will be restored when FACTORY PRESET is pressed on the HARDWARE SETUP screen.
If the MAIN Assy (Touch Panel) is replaced, the factory setting values must be set manually.
The factory setting values can be accessed from Service mode.
HARDWARE SETUP
The video system must be set according to the destination.
Destination
North America
Europe
Japan
China
General
User Data
The following items can be set and stored by the user.
Set the user data if the part is replaced with a repaired part.
HARDWARE SETUP
(Press the POWER switch
while holding the UTILITY
button pressed.)
UTILITY SETUP
(Hold the UTILITY button
pressed.)
5
6
VIDEO SYSTEM
SYSTEM
PAL /NTSC (7.5)/NTSC(0)
TOUCH PANEL Calibration information
Setting Value
/KUCXJ NTSC (7.5IRE)
/WYXJ5 PAL
/JJXJ NTSC (0IRE)
/WAXJ5 PAL
/TLXJ NTSC (0IRE)
OUTPUT BOOTH MONITOR
ON / OFF
TALKOVER THRESHOLD
MIC
-25dB / -20dB / -15dB / -10dB
TALKOVER LEVEL
-25dB / -20dB / -15dB / -10dB
BRIGHTNESS
CONTRAST
COLOR
MASTER OUT
SATURATION
SHARPNESS
BRIGHTNESS
CONTRAST
COLOR
MONITOR OUT
SATURATION
SHARPNESS
VIDEO SYSTEM
PAL /NTSC (7.5)/NTSC(0)
SYSTEM
DIGITAL OUT MAX LEVEL
-19dB / -15dB / -10dB / -5dB
LCD BACKLIGHT
TOUCH PANEL Calibration information
US ENGLISH / UK ENGLISH
/ FRANCAIS / DEUTSCH
KEYBOARD LANGUAGE
/ ITALIANO / NEDERLANDS/ESPANOL
/ PORTUGUES
MIDI CHANNEL
MIDI
6
7
SVM-1000
7
8
A
B
C
D
E
F
43
8