Controlling The Serato Dj Software - Pioneer DJM-S9 Operating Instructions Manual

Controlling the Serato DJ software

Here we explain three types of connections for different usage environments.
! When using analog players, proceed to page 26 .
! When using DJ players, proceed to page 27 .
! When using analog players and DJ players simultaneously, proceed to page 28 .
When using analog players
The following describes how to use the unit by connecting analog players to the Serato DJ software's decks from [DECK1] to [DECK4].
Audio cable
Ground wire
L R
Analog player
CONTROL VINYL
1 Connect the analog player used to control [DECK1]
and [DECK3] to the [PHONO] terminals of [CH1], and the
analog player used to control [DECK2] and [DECK4] to
the [PHONO] terminals of [CH2].
2 Connect the ground wires for the respective analog
players to this unit's [SIGNAL GND] terminals.
3 Set the control vinyls on the analog players.
4 Switch the DJM-S9's input.
Set the [INPUT SELECT] switches of [CH1] and [CH2] to the [
[INPUT SELECT] switch
26
En
To power outlet
To amplifier
5 Select [SETUP] on the Serato DJ software's screen,
then select [TURNTABLES] at the [Audio] tab in the utility
settings.
] side.
Audio cable
Ground wire
L R
Analog player
CONTROL VINYL
Computer