Using External Inputs - Pioneer DJM-S9 Operating Instructions Manual

Using external inputs

This unit is equipped with two external input systems that can be used
for connecting DJ players or analog players. The 2-channel mixer of
this unit can mix the sound of the external input without a computer.
The mixer functions described below operate even if the unit is not con-
nected to a computer.
! For details on the respective items, see Connecting input terminals
(p. 11 ) and Part names and functions (p. 6 ).
! The fader start function (move the channel fader or crossfader while
pressing the [SHIFT] button) cannot be used for the external input.
! The values adjusted with the various controls for the Serato DJ soft-
ware differ from values adjusted for the external input.
Mixer section
2
d
1
3
5
1 TRIM control
2 ISO (HI, MID, LOW) control
3 FILTER control
4 Headphone CUE fader
5 Channel fader
6 Channel Level Indicator
7 MASTER LEVEL control
8 Master level indicator
9 BOOTH MONITOR LEVEL control
a HEADPHONES MIX control
b Crossfader
c HEADPHONES LEVEL control
d INPUT SELECT switch
Front panel
1 CROSS FADER CURVE adjustment control
2 CH FADER CURVE adjustment control
3 CH FADER REVERSE switch
4 CROSS FADER REVERSE switch
Mixing the sound of the microphone
1 Connect the microphone to the [MIC] terminal.
2 Set the [ON, OFF] selector switch to [ON].
— [MIC TALK OVER]: The indicator flashes.
— [TALKOVER OFF]: The indicator lights.
7 9 2
d
1
3
6 8 6 5 c a
4
b
4 1
2 3 32
! When set to [MIC TALK OVER], the sound of channels other than
the [MIC] channel is attenuated by 18 dB (default) when a sound of
–10 dB or greater is input to the microphone.
! The sound attenuation level of [MIC TALK OVER] can be changed
in the utilities mode. For instructions on changing the setting, see
Changing the settings of this unit in the utilities mode (p. 32 ).
3 Turn the [MIC LEVEL] control.
The level of the sound input from the [MIC] channel is adjusted.
! Pay attention that rotating to the extreme right position outputs a
very loud sound.
4 Input audio signals to the microphone.
 Adjusting the sound quality
Turn the [MIC] channels' [EQ (HI, LOW)] controls.
 Applying an echo to the microphone sound
An echo can be applied to the microphone sound by turning the
[MIC ECHO] control.
Mixing the sound of a DJ player, etc.
1 Connect a DJ player or other line level output device
to the [CD/LINE] terminals.
2 Set the [INPUT SELECT] switch to [CD/LINE].
3 Operate the [TRIM] control and the channel faders to
adjust the audio level output from the respective decks.
! The sound can be adjusted with the [ISO (HI, MID, LOW)] controls,
and filter effects can be applied to the respective channels with the
[FILTER] control.
Mixing the sound of analog player, etc
1 Connect the analog player or other phono level (for
MM cartridges) output device to the [PHONO] terminals.
2 Set the [INPUT SELECT] switch to [PHONO].
3 Operate the [TRIM] control and the channel faders to
adjust the audio level output from the respective decks.
! The sound can be adjusted with the [ISO (HI, MID, LOW)] controls,
and filter effects can be applied to the respective channels with the
[FILTER] control.
21
En