Vhf Radio; Gps, Plotter And Radar; Am/Fm Stereo Radio Including Bluetooth, Etc; Internet Hotspot - BENETEAU Pure Joy Too Operation Manual

Sailing vessel
Table of Contents

Advertisement

VHF Radio

The VHF radio is located in the Nav Station. Make sure the breaker is on located at the DC panel
(electronics). Monitor channel 16 at all times. VHF operation is covered in detail in the Beneteau
manual located in the cabinet under the nav. station table. To use the VHF while underway, find the
remote in the drawer under the chart table and plug it into the receptacle on the port side of the
binnacle in the cockpit. Please return the VHF remote to the drawer at the end of your cruise.
A hand-held VHF radio is also provided, located on shelf beneath circuit breaker panel to the port
side of the nav. station table. It can be charged by plugging its charger into the 12 volt (cigarette
lighter) receptacle to the left of the circuit breakers. The Salon Lights breaker must be on.

GPS, Plotter and Radar

Refer to the instruction manuals located in the cabinet below the nav. station table.
Note: The radar will go to standby if the house battery voltage is low, which may occur after a night
at anchor. To keep this from happening, postpone turning on the radar until the engine has been
running for a while. Then bring the RPMs up to 1500 to 2200 and then turn on the radar using the
display plotter. If the radar goes to standby due to low voltage you may have to power down the
display plotter, then power it back up and then restart the radar to resynchronize the radar with the
display plotter. Once you are underway the alternator will bring the house battery back up to full
voltage and the radar should stay on.

AM/FM Stereo Radio including Bluetooth, etc.

The AM/FM stereo unit is located in the Nav Station. It operates like a normal car radio. There are
speakers (stereo) in the salon and on the deck.
You will find a mode selector to the right of the power button that allows you to choose between AM,
FM, WB, CD, Aux, USB, SD, and Bluetooth. WB stands for Weather Band so you can use the
stereo instead of the VHF to listen to weather stations if you like.
The Bluetooth mode allows you to pair your Bluetooth device (e.g. your smart phone) by selecting
Dual BT from your device and entering the password 1234. If you have more than one Bluetooth
device you return the stereo to pairing mode by pressing and holding the little button in the lower left
of the faceplate that is marked with a telephone symbol. This will disconnect the current Bluetooth
device and return the stereo to Bluetooth pairing mode.
**VHF RADIO BREAKER MUST BE ON FOR THE STEREO TO OPERATE.

Internet hotspot

An ATT Unite Pro hotspot is provided. To gain access to the hotspot, have your laptop computer
search wireless networks and select Pure Joy. The password is maple4719. Please do not use the
hotspot for video streaming (e.g. YouTube) or downloading or uploading videos as you will exceed
your 1 gigabyte per week maximum usage and incur and additional charge. If you need to reboot the
hotspot, find the ATT Unite Pro box above the cabinet to the right of the stove. Hold down the power
button (on the edge above the screen) for 1 second to get a prompt requesting Shut Down. Touch the
screen to confirm the shut down. Then start it up again by once again holding down the power again
for 1 second. You will notice that the Hotspot is plugged into a USB receptacle that is just to its
right. To keep that receptacle on and the ATT Unite charging, ensure that the Cabin Lights breaker is
on.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents