Use With Other A/V Products - Mitsubishi WD-52327 Owner's Manual

Use of the Remote Control with Other A/V Products
Programming the Remote Control to Use with Other Brands of Audio and Video
Products:
(Figures 1-4 this page, Figure 5, following page)
1. Move the slide switch at the top of the remote to the product you want to control.
2. Press and hold the POWER button on the remote control.
3. Enter the first three digit code listed for your equipment, and then release the POWER button on the remote
control.
4. Point the remote control to the equipment and press the POWER button.
Note: If the equipment responds,the remote control is properly programmed to operate the equipment.
If the equipment does not respond, repeat steps 2-4 with the next three digit code listed in step 3.
CABLE/DBS/DTV VCR
TV
1.
3.
Cable Box Codes
Cable box brand
Code to enter:
General Instruments/ 119, 120, 121, 122,123,
Jerrold 124
Motorola 125, 126, 127
Oak 139, 137, 102
Pioneer 101, 116
Scientific Atlanta 112, 113
Zenith 117, 100
To reset to default code, enter 000
Figure 1. Programming the remote to control your
cable box.
If you cannot turn the cable box ON
by pressing POWER, try pressing
CHANNEL or the number buttons.
CABLE/DBS/DTV VCR
DVD
TV
1.
3.
Satellite Receiver Codes
Satellite brand
Mitsubishi DTV - DBS
DishNetwork
Hughes - DBS
Panasonic - DBS
RCA - DBS
Sony - DBS
Toshiba-DBS
To reset to default code, enter 000
Figure 2. Programming the remote to control your
satellite receiver.
DVD
AUDIO
POWER
2.
If your
cable box
code is not
listed here,
please see
page 60
for a
complete
listing.
AUDIO
POWER
2.
Code to enter:
If your
006 satellite
receiver
175
code is not
173
listed here,
174
please see
176
page 61 for
177
a complete
170, 173, 189, 190, 191
listing.
CABLE/DBS/DTV VCR
TV
1.
3.
VCR Codes
VCR brand
Code to enter:
Mitsubishi 001, 002
Hitachi 020, 043, 065
JVC 030, 054
Phillips / Magnavox 043, 044, 051
Panasonic 041, 042, 043
RCA 020, 053, 065
Sony 048, 049, 050
Toshiba 021
To reset to default code, enter 000
Figure 3. Programming the remote to control your VCR.
When set to TV, the PLAY, STOP, REW/
REV, and FF/FWD buttons will operate
the VCR after the VCR codes have
been properly programmed into the
remote control.
CABLE/DBS/DTV
VCR
DVD
TV
1.
3.
DVD Player Codes
DVD/LDP brand Code to enter:
Mitsubishi 003
JVC 257
Panasonic 250
Philips 258, 253, 272
Pioneer DVD 252
Samsung 261
Sony 254
Toshiba 253
To reset to default code, enter 000
Figure 4. Programming the remote to control your DVD
or LDP.
DVD
AUDIO
POWER
2.
If your
VCR
code is not
listed here,
please see
page 61
for a
complete
listing.
AUDIO
POWER
2.
If your
DVD
code is not
listed here,
please see
page 60
for a
complete
listing.
25