Mitsubishi WD-52327 Owner's Manual page 18

Connecting a DTV Receiver, continued
DTV Receiver with RGB Video
Connections
(Figure 13)
1. Connect the outside antenna, cable, or satellite to
ANT or SATELLITE IN on the DTV receiver (see your
DTV receiver owner's guide for instructions and
cable compatibility).
2. If your DTV receiver has a built-in integrated tuner,
connect the incoming terrestrial antenna to ANT
on the DTV receiver. If your DTV receiver does not
have a built-in terrestrial tuner, this TV will only be
able to provide an analog signal through Ant-A on
the TV back panel.
3. Connect the RGB cables from the DTV receiver
to the TV back panel as listed below (if your DTV
receiver uses BNC-type cables, use the adaptors
shown in Figure 11, page 17):
DTV Receiver TV Back Panel
G (green) =
B (blue) =
R (red) =
4. If the DTV receiver has outputs for H and V sync,
connect as listed below (DO NOT connect if DTV
receiver uses "Sync on Green"):
H (horizontal sync) =
V (vertical sync)
5. Connect the L (left) and R (right) audio cables from
the DTV receiver to DTV AUDIO on the TV back
panel.
6. To utilize the benefits of a digital A/V receiver,
connect your DTV receiver's digital audio out to a
digital input on your digital A/V receiver. You may
need to setup the DTV (See Input Assignment,
page 33) to RGB.
18
Y/G
Pb/B
Pr/R
H
= V
TV Back Panel (section detail)
COMPONENT DTV
( Y PbPr/ GBRH V )
4 80 i / 4 80P/ 1080i
480 i / 480P /1080 i
1 2
3
Y
3
Pb
3
P r
AUDIO -
L E F T /
AUDIO -
R IG HT
DTV Receiver (witH RGB connections)
3 5
5
3
4
3
4
Figure 13. Connecting the DTV receiver with RGB video
connections.
See Appendix B, page 59, for
component video signal compatibility
information.
For digital audio connections, see your
4
H
4
V
White
5
AUDIO-
LEFT/
(MONO)
5
AUDIO-
Red RIGHT
White
Red
IN FROM ANT
SATELLITE IN
1
or
2
incoming
antenna,
cable or
satellite