Use With Other A/V Products; Programming The Remote Control; Use Of The Remote Control With Other A/V Products - Mitsubishi ws-48413 Owner's Manual

Use of the Remote Control with Other A/V Products

For WS-48413, WS-55413 and WS-65413, the following information is not applicable if you are using NetCommand® IR.

Programming the Remote Control

to Use with Other Brands of Audio
and Video Products:
(Figures 1-3 this page, figures 4-5 following page)
1. Move the slide switch at the top of the remote to
the product you want to control.
2. Press and hold the POWER button on the remote
control.
3. Enter the first three digit code listed for your
equipment, and then release the POWER button
on the remote control.
4. Point the remote control to the equipment and
press the POWER button.
Note: If the equipment responds, the remote control is
properly programmed to operate the equipment. If
the equipment does not respond, repeat steps 2-4
with the next three digit code listed in step 3 for
your equipment.
When set to TV, the PLAY, STOP, REW/REV, and
FF/FWD buttons will operate the VCR after the
VCR codes have been properly programmed into the
remote control.
CABLE/DBS/DTV VCR
TV
1.
3.
Cable Box Codes
Cable box brand
Code to enter:
General Instruments/ 119, 120, 121, 122,123,
Jerrold 124
Motorola 125, 126, 127
Oak 139, 137, 102
Pioneer 101, 116
Scientific Atlanta 112, 113
Zenith 117, 100
To reset to default code, enter 000
Figure 1. Programming the remote to control your
cable box.
If you cannot turn the cable box ON by pressing
POWER, try pressing CHANNEL or the number
buttons.
CABLE/DBS/DTV VCR
DVD
TV
1.
3.
Satellite Receiver Codes
Satellite brand Code to enter:
Mitsubishi DTV - DBS 006
DishNetwork 175
Hughes - DBS 173
Panasonic - DBS 174
RCA - DBS 176
Sony - DBS 177
Toshiba-DBS 170, 173, 189, 190, 191
To reset to default code, enter 000
Figure 2. Programming the remote to control your
satellite receiver.
CABLE/DBS/DTV VCR
DVD
TV
1.
3.
VCR Codes
VCR brand Code to enter:
Mitsubishi 001, 002
Hitachi 020, 043, 065
JVC 030, 054
Phillips / Magnavox 043, 044, 051
Panasonic 041, 042, 043
RCA 020, 053, 065
Sony 048, 049, 050
Toshiba 021
To reset to default code, enter 000
Figure 3. Programming the remote to control your
VCR.
DVD
AUDIO
POWER
2.
If your
cable box
code is not
listed here,
please see
page 68
for a
complete
listing.
AUDIO
POWER
2.
If your
satellite
receiver
code is not
listed here,
please see
page 69
for a
complete
listing.
AUDIO
POWER
2.
If your
VCR
code is not
listed here,
please see
page 69
for a
complete
listing.
27