Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[General Settings] [User Defined] to make the
registration (page 19).
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General Settings] to [Preset] (page 19).
Using the rearview camera
Installation of the rearview camera (not supplied) is
required before use.
The image of a rearview camera connected to the
CAMERA IN terminal is displayed when:
the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
you press HOME, then touch [Rear Camera].
you press and hold DSPL then touch [Rear
Camera] if [SOURCE Key Func.] is set to [DSPL]
(page 19).
36
GB
Installation
Removing the bracket
Before installing the unit, remove the bracket
from the unit.
1
Insert the release keys into the
catches between the unit and the
bracket at the same time until they
click.
Catch
2
Pull down the bracket , then pull up
the unit to separate them.
Face the hook inwards.