The First Wash Cycle; Connecting The Drain Hose; Technical Data; Electrical Connections - Hotpoint Ariston FMSD 822 Instructions For Use Manual

Connecting the drain hose

! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electri-
city socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maxi-
mum power load of the appliance as indicated
in the Technical data table (see opposite);
• the power supply voltage falls within the va-
lues indicated in the Technical data table (see
opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extreme-
ly dangerous to leave the appliance exposed
to rain, storms and other weather conditions.
! When the washing machine has been instal-
led, the electricity socket must remain within
easy reach.
Connect the drain
hose, without bending
it, to a drain duct or
a wall drain situated
between 65 and 100
cm from the floor;
alternatively, placed
it over the edge of a
basin, sink or tub, fa-
stening the duct sup-
plied to the tap (see
figure). The free end
of the hose should
not be underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be repla-
ced by authorised technicians.
Warning! The company shall not be held re-
sponsible in the event that these standards are
not observed.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle number auto clean (see "Cleaning
the washing machine").

Technical data

Model FMSD 822
width 59.5 cm
Dimensions height 85 cm
depth 47.5 cm
Capacity from 1 to 8 kg
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 54 litres
up to 1200 rotations per
Spin speed
minute
Test wash
programme 2 (60°) (1st
cycles in
press of the button);
accordan-
Cotton Standard 60°.
ce with
programme 2 (40°) (2nd
directives
press of the button);
1061/2010
Cotton Standard 40°.
1015/2010
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU
GB
3