Symmetricom ATS-6511A User Manual page 98

Configuring a port to generate the NASA-36 timecode is accomplished using the nasa36
command. NASA-36 can only be generated by a 4387A output module since it is a
modulated timecode.
Configuration of a specific output is stored on the system itself so that replacement modules
will automatically be configured with the correct output format. However, moving the
output module to a different slot causes the system to configure the module with the default
output format until reconfigured by the user.
See also: irig, pps, save
Usage: nasa36 SLOT PORT
SLOT slot number of card
PORT port number of output
Command Examples:
ATS-6511>nasa36 5 2
Query:
ATS-6511> settings hardware:slots:5
[tsc4387]
[ports]
[1]
[format] B
[signal_word] 120
[type] irig
[2]
[format] B
[signal_word] 120
[type] nasa36
[3]
[format] B
[signal_word] 120
[type] irig
[4]
[format] B
[signal_word] 120
[type] irig
Network:
Description: Show network interface configuration. The network command displays all
the network interface variables for the system. Network variables are values that are
settable by the user and are automatically saved by the system. Network settings are
physically stored on the flash though so they will be lost if the flash is replaced. They will
not be lost during a software update. This command is equivalent to the show network
command and the network variables also appear on the status port (port
1900).
Syntax: network
ATS-6511A/B/C Users Guide
92
DOC 6511_Release K