Symmetricom ATS-6511A User Manual page 102

enable
default Change the prompt for all future sessions
Command Example:
This command changes it for the current session.
ATS-6511>prompt –text Test
Test>
ATS-6511>prompt –enable 0
Prompt is no longer visible. This change is only in effect for the current telnet session.
Command Example:
This command makes it the system default.
ATS-6511>prompt –text Test --default
ATS-6511>
ATS-6511>prompt –enable 0 --default
ATS-6511>
Query:
ATS-6511>settings command_port
[prompt]
[enable] true
[text] Test>
Note: Making any changes without the –default option will impact the current session and
will not impact the system settings. Using the –default option will change the system
settings (settings command_port) values and will be used the next time the user makes a
command port connection. These settings must also be saved.
Ptdavg:
Description: Set PTD averaging interval in seconds. Changes the PTD (Phase Time
Difference) averaging interval for the pulse measurement data displayed on the ptdavg_port
(port 2100). The averaging interval is applied to all of the measurement channels and can't
be individually configured on a port by port basis.
Note: This command is only valid when a 4393A PPS measurement module is installed in
the system.
Syntax: ptdavg [1|10|20|60|300]
Command Example:
ATS-6511>ptd 10
Query:
ATS-6511>settings ptd_port
[averaging_interval] 10
[OK] 2010-05-25T20:31:58Z
1 displays the prompt; 0 hides the prompt
Changes the prompt immediately, only in effect for the current telnet session.
Note: Prompt does not change until the next command port connection is made.
Prompt is still visible, Prompt does not disappear until the next
command port connection is made.
96
DOC 6511_Release K
ATS-6511A/B/C Users Guide