Calibrating The Bebop 2; Flat Trim; Gps Signal - Parrot BEBOP 2 User Manual

Calibrating the Bebop 2

When you use the Bebop 2 for the first time, the calibration screen appears.
1. Follow the procedures on the screen.
2. Once you completed the three steps, press
Note:
You can also calibrate your Bebop 2 if it is unstable in flight. To do so, go to
settings.

Flat trim

The flat trim setting is a means to reset the sensors to a hori
your drone is unstable in flight or following a crash.
To flat trim:
1. Place the Bebop 2 on a flat, dry, unobstructed surface.
2. In the FreeFlight 3 application, go to
3. Press

GPS signal

Note:
If you are in an area with no GPS reception, the Bebop 2 position will not be
detected.
The icon indicates that the Bebop 2 position is not detected.
The icon indicates that the Bebop 2 position is detected.
Make sure the Bebop 2 position is detected before taking off to register the starting point
correctly.
To display the last GPS position of the Bebop 2:
1. Launch FreeFlight 3.
2. On the main screen, go to
3. Press
> The latitude and longitude of the Bebop 2 position appears in the list.
12
Flying
Flat Trim.
See details.
.
> Flight settings.
> Settings.
>Flight
ontal plane. This is used if
z