Maintenance; Cleaning; Engine; Maintenance Schedule - MK Diamond Products MK-2013 HSP Owner's Manual

Maintenance

Periodic maintenance including cleaning, lubrication, tensioning of drive belts, and inspection for wear and damage are routine
servicing procedures. Following the procedures as outlined in the following table can prevent serious damage or malfunctioning of the
machine and aid in preserving the useful life of saw blades.
Warning
on
Item performed at
every indicated hours
or interval period
whichever goes first.
Air Filter
Hydrostatic
Transmission
reservoir
on
Mainframe
Battery

Engine

Warning
Shut off the engine before performing any maintenance. If the engine must be run after a maintenance operation make sure the area
is well ventilated. The exhaust contains poisonous carbon monoxide gas! Exposure can cause loss of consciousness and may result in
death.

cleaning

Clean the machine daily being careful to remove cutting dust and slurry from the blade guard engine cooling fan and air ducts. Failure
to perform this operation may prevent smooth control of the saw. Steam cleaning is the preferred method of cleaning.
engine
Engine maintenance and adjustment is necessary to keep the saw in good operating condition. Maintenance operations include oil
changes, filter changes, air cleaner, spark plug, fuel filter, etc. Perform all maintenance procedures as recommended by the Honda
Engine Manual provided separately.
For a new engine, it is especially important to change the oil after the first 5 hours of operation. Thereafter, change the oil after every
100 hours of operation as per the engine manufacturers manual.
Note
: Always dispose of used engine oil and filters in a responsible manner. Follow your community's standards for disposing of these
items. Call your local recycling center to find out about recycling engine oil.
MK-20 SERIES
Before servicing the saw or engine, always turn the kill switch to the off position.

Maintenance Schedule

every 8 hours
maintenance
or daily
operation
every 4 hours
Check
when dry
cutting
when dry
cutting
Change air
filter
Check oil
lube blade
Blade
shaft bearings
shaft
at end of
bearings
operations
Pivot
Bearings
Chain Drive
Transmission
control
Assemblies
Battery
V-Belts
check water
level
Definitive information on engine maintenance is contained in
the or Honda Engine Manual provided separately. Perform all
maintenance procedures as recommended by the Engine Manual.
Revision 09/06, Effective Date September 18, 2006
25 hours
100 hours or
or weekly
seasonal
Adjust
tension
replace
11